Custom HD Ignition Switch Bracket with Hardware - Only at RE-DO Banshee!

The Factory OEM Banshee ignition switch bracket is very thin and weak. When removing or reinstalling the bracket, there’s a sequence you must follow, or the bracket often bends.

The correct sequence to follow to remove the bracket is:

• Loosen the bottom 2 bolts on the handlebar clamp.
• Remove the top 2 bolts that are holding the OEM or aftermarket ignition switch bracket on. 
• Remove the bracket.
• To reinstall, reverse the order.

When you do this out of order, the thinner OEM ignition switch bracket bends. If you are looking to repair your Banshee and keep it Factory OEM, it's hard to find these brackets because they bend so often. 

Re-Do Banshee manufactures this heavy duty ignition switch bracket based on the template of an OEM bracket.  Re-Do then pairs the bracket with used OEM bolts, which are JIS bolts, and sells this part.  Pairing these together provides a high-quality OEM replacement part at a great value to our customers. 

Click the link to buy the bracket on our website: 

RE-DO Custom HD Ignition Switch Bracket 

Is this a good OEM replacement part? Comment below ⬇️